J-bond Computer Systems Corp.

[PCI400C-C]

 If you want to update the BIOS by flashing, you must have a flashable
EPROM named MXIC 28F1000 (Vpp=12v) and there are JP16 jumper pins on
your PCI400C-C.

Here is a list of these support files :

File Name       Description                  size (bytes)
*********************************************************
readme.txt      this file		     1829

awdflash.exe    BIOS update utility          4961


4ccxxxxx.bin    new BIOS filename            131072
                for system board (PCI400C-C)


************   Updating Your System BIOS   ************

To update your system BIOS, perform the steps described below. Please read
through all of the steps carefully before beginning.


1. Pins 1-2 and 5-6 of jumper JP16 must be shorted for flashing.

2. Boot your system from a DOS system diskette that contains no config.sys
   or autoexec.bat file. (If the diskette contains a config.sys or
   autoexec.bat file, the BIOS updating program will not work properly.)

3. Place the BIOS update disk into drive A (or drive B). The BIOS update
   disk contains TWO files: there are AWDFLASH.EXE and the new BIOS data
   file 4CCXXXXX.BIN. Run the following command line:

   AWDFLASH 4CCXXXXX.BIN

   When the program asks "Do You Want To Save Bios (Y/N)", answer N.
   When the program asks "Are you sure to program (y/n)", answer Y.

   After finishing flashing, reboot your system. Then the procedure of
   updating BIOS is done.

!! IMPORTANT: Do not power off or reset the computer while the BIOS updating
              operation is in progress. If you do so, you will never be
              unable to start your system again.

4. After flashing, Pins 2-3 and 4-5 of jumper JP16 must be shorted for
   for normal operating.


