             Aztech EM6800-A firmware re-flash software               130199
             ==========================================               ======

1. System requirements

        To run the program, a PC compatible computer is required with a 
        EM6800-A installed onto a spare serial port (COM1 preferred).

        The program runs from DOS version 6.22 and higher. The program 
        does not run in DOS window under any version of Windows or under 
        any DOS extenders.

2. Running the re-flash

        This utility runs in DOS only. Do not attempt to use in a DOS-Box
        under windows.

        To run the re-flash, enter the following command:

        EM6800-A.EXE

        No command line parameter is required.

3. Flash Verification

        To verify that the flash is flashed correctly, go to Hypererminal
        in Windows and type "ATI1".

        You will see "B619". This is the checksum of this updated
        firmware flash.

        This verified that the flashing is successfully done.


