Installation of miroVIDEO 12PD drivers for Windows95:

Attention: Please don't try to install the miro drivers by running the
           install.exe program. Use 'change display properties'
           from your control panel.

To install the miro drivers, proceed as follows:

* If you have not done so already, start your computer
* Open the Control Panel
* Click on Display
* Click the Settings folder
* Select Change Display Type... .The Change Display Type windows appears.
  Here you can change the graphics board and the monitor type.
* To select another graphics board, click on the "Change" button.
* Click "Have Disk..." To specify the disk drive from which you install 
  the drivers: default is drive a:\.
  Now there will be displayed the following model either
  "miroVIDEO12PD".
  The computer is restarted. After the restart the new resolutions are 
  available.

Knowing restrinctions for the 2MB version:

With some monitors the 1152x864x16 resolution may be flickering.

Hint:
Using an Intel Endeavor board it could happen that you see a wild flickering 
opening your BIOS setup. In this case you don't have the actual BIOS version 
of your Intel Endeavor board. Please update your BIOS immediately.
              